Subaru Crosstrek Service Manual: Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check Sleeve
ASSEMBLY
1. Install the return spring (1st-2nd), return spring cap, reverse accent shaft, reverse check cam, return spring (5th-Reverse) and reverse check spring.
NOTE:
Be sure to insert the curved part of reverse check spring into the check cam groove.
(A) | Reverse check plate |
(B) | Reverse check spring |
(C) | Return spring (5th-Reverse) |
(D) | Reverse check cam |
(E) | Reverse accent shaft |
(F) | Return spring cap |
(G) | Return spring (1st-2nd) |
2. Hook the curved part of reverse check spring onto the reverse check plate.
3. Rotate the cam so that the protrusion on the reverse check cam is located at the plate opening.
4. While fixing the cam to that position, attach the reverse check plate to the reverse check sleeve, and secure with snap ring.
5. Insert the O-ring into the sleeve groove.
NOTE:
Use new O-rings.
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the ...
Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveDISASSEMBLY1. Cover the reverse check sleeve with cloth, and remove the snap ring by using screwdriver.NOTE:If the snap ring is defor ...
Other materials:
Installation
LUBRICATION(H4DO) > Oil PanINSTALLATION1. OIL PAN1. Apply liquid gasket to the mating surface of the oil pan upper as shown in the figure, and install the oil pan.NOTE:• Before applying liquid gasket, degrease the old liquid gasket seal surface of the oil pan and the oil pan upper.• U ...
Safety precautions
WARNING
If you are using an implanted pacemaker or defibrillator, maintain a
safe distance of at least 8.7 in (22 cm) from the transmitting antennas installed
in the Subaru Ascent.
The Subaru Ascent keyless access system emits radio waves that may interfere
with the normal operation o ...
Removal
LIGHTING SYSTEM > Hazard SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the center grille assembly. Air Vent Grille > REMOVAL">3. Release the claws, and remove the switch - hazard from the center grille assembly. ...
