Subaru Crosstrek Service Manual: Inspection

1.CHECK ENGINE OIL AMOUNT.

Is the engine oil amount normal? Engine Oil > INSPECTION">

Oil Pressure System > INSPECTION">Go to Step 2.

Adjust the engine oil amount. Engine Oil > INSPECTION">
After the operation is complete, go to the next step. Oil Pressure System > INSPECTION">Go to Step 2.

2.CHECK DTC.

Is DTC for engine displayed? Read Diagnostic Trouble Code (DTC)">

Check the appropriate DTC using the “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)">

Oil Pressure System > INSPECTION">Go to Step 3.

3.CHECK POWER SUPPLY TO OIL PRESSURE SWITCH.

1) Turn the ignition switch to OFF.

2) Disconnect the terminal from oil pressure switch.

3) Turn the ignition switch to ON (engine OFF).

4) Measure the voltage of harness between oil pressure switch harness terminal and chassis ground.

Terminals

(E11) No. 1 (+) — Chassis ground (−):

Is the voltage 10 V or more?

Replace the oil pressure switch. Oil Pressure Switch">

Oil Pressure System > INSPECTION">Go to Step 4.

4.CHECK COMBINATION METER.

Perform the self-diagnosis of combination meter to check if there are any faults in the combination meter. Combination Meter System > OPERATION">

Is combination meter OK?

Repair the harness and connector.

NOTE:

In this case, repair the following item:

• Open circuit or short circuit of harness between combination meter and oil pressure switch

• Poor contact of combination meter connector

• Poor contact of coupling connector

Repair or replace the combination meter. Combination Meter System > INSPECTION">

Oil pressure system

Wiring diagram

Other materials:

Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Steering ColumnINSPECTION1. UNIT INSPECTIONCheck the following items, and if there is anything out of standard value, it is considered to be damaged. If so, replace it with a new part.• Measure the whole length of the column assembly - steering.Stand ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Driven GearINSTALLATION1. Install the transfer driven gear assembly.2. Install the transfer clutch assembly. Transfer Clutch > INSTALLATION">3. Select the transfer driven gear shim. Transfer Clutch > ADJUSTMENT">4. Insta ...

Removal
STARTING/CHARGING SYSTEMS(H4DO) > StarterREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) securing the air cleaner case (rear) to the air intake boot.4. Loosen the clamp (C) which secures the throttle body t ...