Subaru Crosstrek Service Manual: Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR Pipe
INSTALLATION
1. Temporarily install the EGR pipe to the intake manifold and water pipe assembly, and tighten the EGR pipe in numerical order as shown in the figure.
NOTE:
Use a new gasket.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
2. Install the throttle body to the intake manifold.
Tightening torque:
8.0 N·m (0.8 kgf-m, 5.9 ft-lb)
3. Connect the connector to the throttle body.
4. Install the air intake boot. Air Intake Boot > INSTALLATION">
5. Connect the battery ground terminal.
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR PipeREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake ...
Other materials:
Assembly
FRONT SUSPENSION > Front ArmASSEMBLY1. BUSHING FRONT - FRONT ARM1. Before assembly, inspect the following items and replace any faulty part with a new one.• Check the front arm assembly for damage or cracks, and replace if defective.• Visually check the bushing for abnormal cracks, fa ...
Certification for the BSD/RCTA
U.S.-spec. models:
FCC ID: OAYSRR2A
CAUTION
FCC WARNING
Changes or modifications not expressly
approved by the party responsible
for compliance could void
the user's authority to operate the
equipment.
This device complies with part 15 of the
FCC Rules. Operation is subject to the
followi ...
Dtc p2270 o2 sensor signal biased/stuck lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2270 O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...
