Subaru Crosstrek Service Manual: Dtc b1010 body control system (biu) malfunction

DTC DETECTING CONDITION:

System error in body integrated unit

TROUBLE SYMPTOM:

LAN communication immobilizer function may not be executed normally.

1.CHECK DTC.

Check DTC indicated by body integrated unit. Read Diagnostic Trouble Code (DTC)">

Is B1010 current malfunction?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1010 BODY CONTROL SYSTEM (BIU) MALFUNCTION">Go to Step 2.

Temporary EEPROM access error occurred.

2.CHECK CONNECTOR.

1) Turn the ignition switch to OFF.

2) Disconnect the body integrated unit connector.

3) Connect the disconnected connectors.

4) Read the DTC of body integrated unit using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">

Is B1010 current malfunction?

Replace the body integrated unit. Body Integrated Unit">

Temporary EEPROM access error occurred.

Dtc b1411 immobilizer antenna

Dtc b1011 battery control power supply

Other materials:

Daytime running light system
WARNING When the daytime running lights of the Subaru Ascent are active, the tail lights remain off. As ambient light decreases, always switch the light control to the " " position to activate both headlights and tail lights. This significantly improves visibility and ensures tha ...

Dtc b2271 ign relay control circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2271 IGN RELAY CONTROL CIRCUITDTC detecting condition:• When malfunction is detected in IG1 and IG2 drive circuits in the keyless access CM.• When malfunction is de ...

Operation
VEHICLE DYNAMICS CONTROL (VDC) > VDC Sequence ControlOPERATION1. While the VDC sequence control is performed, the operation of the hydraulic unit can be checked using the brake tester or pressure gauge after the hydraulic unit solenoid valve is operated.2. VDC sequence control can be started by S ...