Subaru Crosstrek Service Manual: Body control system (diagnostics)
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u1500 keyless uart com. Malfunction
- Dtc b1016 shift lock circuit
- Dtc b1401 meter collation
- Dtc b1402 immobilizer key collation
- Dtc b1405 scu collation
- Dtc b1406 scu_eeprom
- Dtc b1407 met communication
- Dtc b1408 meter non-volatile memory
- Dtc b1409 scu communication
- Dtc b1410 transponder communication
- Dtc b1411 immobilizer antenna
- Dtc b1010 body control system (biu) malfunction
- Dtc b1011 battery control power supply
- Dtc b1012 battery backup power supply
- Dtc b1013 ignition power
- Dtc b1014 acc power
- Dtc b1015 key interlock circuit
- General description
- Read current data
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Control module i/o signal Electrical specification
- Electrical component location Location
- Function check Operation
- General diagnostic table Inspection
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
- Registration body integrated unit Operation
- User customizing Operation
Outer mirror assembly Note
Blind Spot Detection/Rear Cross Traffic Alert > Outer Mirror AssemblyNOTEFor the operation procedures for the outer mirror assembly, refer to “GLASS/WINDOWS/MIRRORS” section. Outer Mir ...
Other materials:
Removal
EXHAUST(H4DO) > MufflerREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Turn the ignition switch to OFF.2. Lift up the vehicle.3. Remove the bolts and self-locking nuts which secure the rear exhaust pipe to the muffler.4. Apply a c ...
Removal
SECURITY AND LOCKS > Starter Relay (Push Button Start)REMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from bat ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve ActuatorREMOVAL1. Disconnect the ground cable from battery.2. Disconnect the connector (A) from tumble generator valve assembly, and remove the tumble generator valve actuator.• RH side• LH side ...
