Subaru Crosstrek Service Manual: Function check Operation

NOTE:

In order to check the body integrated unit function, inspect the body integrated unit and actuator using Subaru Select Monitor without operating switches.

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Body Control» and then select «Enter».

5. On «Select Function» display, select «Active Test».

NOTE:

• If not equipped (depending on destination area or vehicle equipment condition), process will not go on.

• The operation is disabled for the models with keyless access with push button start system because the key lock solenoid is not installed.

• For detailed operation procedures, refer to “Application help”.

Electrical component location Location

General diagnostic table Inspection

Other materials:

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle BodyREMOVAL1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL">4. Drain approximately 3.0 L (3.2 US qt, 2.6 Imp qt) of coolant. Engine Coolant > REPLACEMENT"& ...

Gasoline for cleaner air
Your use of gasoline with detergent additives will help prevent deposits from forming in your engine and fuel system. This helps keep your engine in tune and your emission control system working properly, and is a way of doing your part for cleaner air. If you continuously use a high qualit ...

Inspection
WHEEL AND TIRE SYSTEM > Tire and WheelINSPECTION1. TIRECAUTION:When replacing a tire, make sure to use tires of the same size, construction and load range as originally installed.1. Tire size and tire inflation pressure check General Description > SPECIFICATION">2. Cracks, damage and ...