Subaru Crosstrek Service Manual: Clear memory mode Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Body Control» and then select «Enter».

5. On «Select Function» display, select «DTC».

6. On «DTC» display, select «Clear Memory».

NOTE:

For detailed operation procedures, refer to “Application help”.

Check list for interview Check

Control module i/o signal Electrical specification

Other materials:

Installation
SECURITY AND LOCKS > Steering Lock CMINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type D” described in “REGISTRATION MANUAL FOR ...

Removal
LIGHTING SYSTEM > Hazard SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the center grille assembly. Air Vent Grille > REMOVAL">3. Release the claws, and remove the switch - hazard from the center grille assembly. ...

Hill start assist warning light/Hill start assist OFF indicator light
Hill start assist warning light While the engine is running, if there are any malfunctions in the Hill start assist system, the warning light will illuminate. WARNING When the Hill start assist warning light illuminates, have the vehicle inspected at an authorized SUBARU dealer. Hill st ...