Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b11e0 rollover deployment history

AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code

DTC B11E0 ROLLOVER DEPLOYMENT HISTORY

DIAGNOSIS START CONDITION:

Ignition voltage is 10 V to 16 V.

DTC DETECTING CONDITION:

This DTC is indicated when the curtain airbag module and the seat belt pretensioner are deployed.

Once this DTC is displayed, the memory cannot be cleared. Replace the following parts.

Airbag control module Airbag Control Module">

Curtain airbag module Curtain Airbag Module">

Front outer seat belt with pretensioner Front Seat Belt">

Dtc b1000 airbag ecu malfunction
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1000 AIRBAG ECU MALFUNCTIONDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Airbag control mod ...

Dtc b11f2 front impact deployment
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11F2 FRONT IMPACT DEPLOYMENTDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:This DTC is indic ...

Other materials:

Dtc p0037 a/f / o2 heater control circuit low bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0037 A/F / O2 HEATER CONTROL CIRCUIT LOW BANK 1 SENSOR 2DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear M ...

Switching power status
Operation indicator Push-button ignition switch The power status is switched every time the push-button ignition switch is pressed. 1. Carry the access key, and sit in the driver's seat. 2. Shift the select lever into the "P" position. 3. Press the push-button ignition switch ...

Dtc b1010 body control system (biu) malfunction
BODY CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1010 BODY CONTROL SYSTEM (BIU) MALFUNCTIONDTC DETECTING CONDITION:System error in body integrated unitTROUBLE SYMPTOM:LAN communication immobilizer function may not be executed normally.STEPCHECKYESNO1 ...

© 2016-2026 Copyright www.sucross.com