AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code
DTC B11F2 FRONT IMPACT DEPLOYMENT
DIAGNOSIS START CONDITION:
Ignition voltage is 10 V to 16 V.
DTC DETECTING CONDITION:
This DTC is indicated when the front airbag module and the pretensioner are deployed.
Once this DTC is displayed, the memory cannot be cleared. Therefore replace the following parts.
• Airbag control module Airbag Control Module">
• Driver’s airbag module Driver’s Airbag Module">
• Passenger’s airbag module Passenger’s Airbag Module">
• Driver’s knee airbag module Knee Airbag Module">
• Front sub sensor of both sides Front Sub Sensor">
• Front outer seat belt with pretensioner of both sides Front Seat Belt">
• Steering roll connector Roll Connector">
• Occupant detection system (passenger’s seat cushion & frame assembly) Front Seat">
• Curtain airbag module on both sides (when activated) Curtain Airbag Module">
Dtc b11e0 rollover deployment history
Dtc b11f3 front impact deploymentRemoval
SECURITY AND LOCKS > Keyless BuzzerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the clips and screws, and turn over the front side of the mud guard - front RH.4. Remove the keyless buzzer.(1) Disconnect the connector.(2) Remove the clip and d ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Case and Extension Case AssemblyINSTALLATION1. Clean the mating surfaces of the transmission case, transfer case and extension case.2. Apply a coat of grease to the taper roller bearing (transfer case side) of transfer driven gear and the rolle ...
Component
DIFFERENTIALS > General DescriptionCOMPONENT1. REAR DIFFERENTIAL (T-TYPE)(1)Hypoid driven gear and drive pinion set(14)O-ring(27)Filler plug(2)Pinion height adjusting washer(15)Side retainer shim(28)Drain plug(3)Rear bearing(16)Side retainer(29)Rear cover(4)Preload adjusting spacer(17)Side oil se ...