Subaru Crosstrek Owners Manual: Daytime running light system
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the "
" position when it
is dark outside.
The high beam headlights will automatically
illuminate at reduced brightness
when the following conditions are fulfilled.
- The engine is running.
- The parking brake is fully released.
- The light control switch is in the
"AUTO" (if equipped), "
" or
off position.
- For CVT models, the select lever is in a
position other than the "P" position.
NOTE
- When the light switch is in the "
"
position, the instrument panel illumination,
front side marker lights, tail lights
and license plate lights are also illuminated.
- For models with the auto on/off
headlights, while the light control
switch is in the "AUTO" position and
the system is activated to the auto-on
mode depending on the ambient light
level, the high beam headlights that
have illuminated at reduced brightness
turn off, and the low beam headlights
turn on alternatively. At this time, the
instrument panel illumination, front
side marker lights, tail lights and
license plate lights are also illuminated.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on fo ...
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatica ...
Other materials:
Removal
CLUTCH SYSTEM > Master CylinderREMOVALCAUTION:• Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.• Before handling the airbag system components, refer to “CAUTIO ...
Installation
SECURITY AND LOCKS > Security Control ModuleINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type B” described in “REGISTRATION MAN ...
Installation
DRIVE SHAFT SYSTEM > Propeller ShaftINSTALLATION1. Before installation, check the following items, and replace the propeller shaft assembly as necessary.• Dents or cracks on the tube surface• Splines for deformation or abnormal wear• Unsmooth joint operation or abnormal noise&bu ...
© 2016-2023 Copyright www.sucross.com
