Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Receiving a call

Incoming calls

When a call is received, the incoming call screen is displayed with a sound.

When you receive a phone call while the cell phone is connected, the screen changes to the incoming call screen.

Incoming call screen
Incoming call screen

  1. Open the "Options" screen. Refer to "Phone volume settings"
  2. Put the incoming call on hold. This function may not work on some cell phone models. This function is the same as pressing the on hook switch on the steering wheel for a short period of time.
  3. Open the call screen. This function is the same as pressing the off hook switch on the steering wheel.
  4. Reject the incoming call. This function is the same as pressing and holding the on hook switch on the steering wheel.

NOTE

By off/on hook switch

When you receive a call, you can also answer it by pressing the off hook switch on the steering wheel. To end a call, press the on hook switch.

Outgoing screen
Outgoing call screen Open the "Options" screen. Refer to "Phone volume settings" Abort the call. The screen returns to the phone (menu) screen. This is the same as pressing the on hook ...

Talking on the phone
The call screen opens when you perform the following operations. When you accept a call on the incoming call screen (by selecting the   key), the call screen opens. When you are on ...

Other materials:

Dtc c1222 front left abs sensor signal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1222 FRONT LEFT ABS SENSOR SIGNALNOTE:For the diagnostic procedure, refer to “DTC C1242 REAR LEFT ABS SENSOR SIGNAL”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...

Dtc u0101 lost communication with tcm
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...

Disassembly
CLUTCH SYSTEM > Master CylinderDISASSEMBLY1. Remove the straight pin and nipple.(A)Nipple(B)Straight pin2. Remove the oil seal.(A)Oil seal3. Move the seat towards the rear.(A)Seat(B)Master cylinder4. Remove the piston stop ring.CAUTION:When removing the piston stop ring, be careful to prevent the ...

© 2016-2026 Copyright www.sucross.com