EXTERIOR/INTERIOR TRIM > Front Grille
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the bumper face - front. Front Bumper > REMOVAL">
3. Remove the front grille assembly.
(1) Remove the screws from the back side of the bumper face - front.
(2) Release the claws, and remove the front grille assembly.
InstallationComponent
PARKING BRAKE > General DescriptionCOMPONENT1. PARKING BRAKE (REAR DISC BRAKE)(1)Back plate - rear brake(7)Spring - secondary shoe return(13)Cup - shoe hold-down(2)Retainer - rear brake(8)Spring - strut(14)Parking brake shoe (primary)(3)Spring washer - rear brake(9)Strut - brake(15)Pin - primary ...
Stowage of the cargo area cover
The cargo area cover can be stowed in
under the cargo floor.
1. Raise and fold the rear end of the
cargo floor board.
2. Stow the cover housing in the cargo
area end.
3. Put the cargo floor board back while
hanging two retaining straps on the hooks
that are located on the rear wa ...
Dtc p0365 camshaft position sensor "b" circuit bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0365 CAMSHAFT POSITION SENSOR "B" CIRCUIT BANK 1DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine stall• Failure of engine to startCAUTION:After servicing ...