ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P1495 COIL 2 EGR "A" CONTROL CIRCUIT HIGH
NOTE:
For the diagnostic procedure, refer to DTC P1499. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P1499 COIL 4 EGR "A" CONTROL CIRCUIT HIGH">
1. OUTLINE OF DIAGNOSIS
NOTE:
For the detection standard, refer to DTC P1493. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P1493 COIL 1 EGR "A" CONTROL CIRCUIT HIGH">
Dtc p1494 coil 2 egr "a" control circuit low
Dtc p1496 coil 3 egr "a" control circuit lowMap light
Type A
1. Remove the lens by prying the edge of
the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at
its ends are aligned vertically. Pull the bulb
straight downward to remove it.
3. Install a new bulb.
4. Reinstall the lens.
Type B
1. Remove the lens ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Wiring HarnessREMOVAL1. Release the fuel pressure. Fuel > PROCEDURE">2. Disconnect the ground cable from battery.3. Remove the intake manifold. Intake Manifold > REMOVAL">4. Disconnect the connector from the engine.• Struc ...
Drive cycle Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Drive CyclePROCEDUREIt is necessary to perform the drive cycle listed below if DTC is not found in the Inspection Mode. It is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform a necessary drive cyc ...