Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b2a07 backup battery charge system performance

TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC B2A07 BACKUP BATTERY CHARGE SYSTEM PERFORMANCE

DIAGNOSIS START CONDITION:

When ignition switch is ON.

DTC DETECTING CONDITION:

Backup battery is disconnected for at least 5 seconds when the ignition switch is turned ON. (Detached backup battery connection, etc.)

TROUBLE SYMPTOM:

ACN/SOS function cannot be used when the main battery is disconnected.

RED LED illuminates.

CAUTION:

CommCheck is required after replacing the DCM. Telematics System > OPERATION">

STEPCHECKYESNO

1.CHECK DTC.

Read the DTC. Diagnostic Code(s) Display">

Is DTC B2A07 displayed? (Current malfunction)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A07 BACKUP BATTERY CHARGE SYSTEM PERFORMANCE">Go to Step 2.

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

2.CHECK BACKUP BATTERY.

1) Remove the DCM. Data Communication Module">

2) Remove the backup battery cover.

3) Disconnect the backup battery connector.

4) Measure the backup battery voltage.

Is the voltage 2.0 V or more?

Replace the DCM. Data Communication Module">

Replace the backup battery. Data Communication Module">

Dtc u0151 lost communication with restraints control module
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0151 LOST COMMUNICATION WITH RESTRAINTS CONTROL MODULEDetected when CAN data is not received from airba ...

Dtc b2a10 battery voltage high
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A10 BATTERY VOLTAGE HIGHDiagnosis start condition:When ignition switch is ON.DTC detecting condition:D ...

Other materials:

BSD/RCTA OFF switch
BSD/RCTA OFF switch BSD/RCTA OFF indicator If the BSD/RCTA OFF switch is pressed, the BSD/RCTA OFF indicator appears on the multi information display of the combination meter, and the BSD/RCTA is deactivated. Press the switch again to activate the BSD/RCTA. The BSD/RCTA OFF indicat ...

Battery
WARNING Before beginning work on or near any battery, be sure to extinguish all cigarettes, matches, and lighters. Never expose a battery to an open flame or electric sparks. Batteries give off a gas which is highly flammable and explosive. For safety, in case an explosion do ...

Preparation tool
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor ...

© 2016-2026 Copyright www.sucross.com