Subaru Crosstrek Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc b2a01 tel1 antenna circuit
- Dtc u0452 invalid data received from restraints control module
- Dtc b2a02 tel2 antenna circuit
- Dtc u0100 lost communication with ecm/pcm a
- Dtc b2a00 vin reading
- Dtc b2a03 gps antenna circuit
- Dtc b2a04 mic circuit
- Dtc b2a05 left speaker/audio circuit
- Dtc b2a06 right speaker/audio circuit
- Dtc b2a08 sos button circuit
- Dtc b2a09 i-call button circuit
- Dtc b2a0a red led circuit
- Dtc b2a0b green led circuit
- Dtc b2a0c dcm internal fault
- Dtc b2a0d airbag signal
- Dtc b2a0e mute line circuit
- Dtc b2a0f backup battery degradation
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0140 lost communication with body control module
- Dtc u0151 lost communication with restraints control module
- Dtc b2a07 backup battery charge system performance
- Dtc b2a10 battery voltage high
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc u0401 invalid data received from ecm/pcm a
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0073 control module communication bus off
Operation
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Code(s) DisplayOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and sele ...
Dtc b2a01 tel1 antenna circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A01 TEL1 ANTENNA CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:A ...
Other materials:
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > In-Vehicle Sensor (Auto A/C Model)INSPECTION1. Set the vehicle to the following conditions.ItemConditionIgnition switchONA/C switchONTemperature adjustment dialHI (MAX HOT)Air flow control dial or switchDEFFan dialHI (MAX)2. Check the suction port (A) fo ...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearADJUSTMENT1. Select the appropriate reverse shifter lever from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.Clearance A:6.0 — 7.5 mm (0.236 — 0.29 ...
Dtc c0035 rr hold valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0035 RR HOLD VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
