Subaru Crosstrek Service Manual: Dtc u0100 lost communication with ecm/pcm a
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”
Detected when CAN data from ECM does not arrive.
NOTE:
Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE">
Dtc b2a02 tel2 antenna circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A02 TEL2 ANTENNA CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:A ...
Dtc b2a00 vin reading
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A00 VIN READINGDiagnosis start condition:When ignition switch is ON.DTC detecting condition:When ignit ...
Other materials:
Removal
SECURITY AND LOCKS > Keyless Access Indoor AntennaREMOVAL1. FRONT ANTENNA1. Disconnect the ground cable from battery. NOTE">2. Remove the cover - shift lever. Console Box > REMOVAL">3. Disconnect the connector and remove the front antenna assembly - interior.2. REAR ANTENNA1. ...
Brake system warning light
In the Subaru Ascent, the brake system warning light illuminates when the parking
brake is engaged while the ignition switch is in the "ON" position. This is a normal
operational indication. Once the parking brake is fully released, the light should
turn off immediately, confirming t ...
Removal
REAR SUSPENSION > Front Lateral LinkREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the bolts and nuts, and then remove the trailing link.3. Remove the lateral link assembly - front.(1) Remove the snap pin (a) and nut (b).(2) Remove the ball joint from the housing assembl ...
