Subaru Crosstrek Service Manual: Dtc b2a02 tel2 antenna circuit

Diagnosis start condition:

When ignition switch is ON.

DTC detecting condition:

Any of the followings continues for 5 seconds or more.

• TEL2 impedance is more than 1 M?. (Detached antenna, etc.)

• TEL2 impedance is less than 1 k?. (Short-circuited antenna, etc.)

• Telematics function cannot be used.

• RED LED illuminates.

CommCheck is required after replacing the DCM. Telematics System > OPERATION">

1.CHECK DTC.

Read the DTC. Diagnostic Code(s) Display">

Is DTC B2A02 displayed? (Current malfunction)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A02 TEL2 ANTENNA CIRCUIT">Go to Step 2.

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

2.CHECK ANTENNA.

Visually check the telematics sub antenna. Antenna">

Is the telematics sub antenna OK?

Replace the DCM. Data Communication Module">

Replace the telematics sub antenna. Antenna">

Dtc u0452 invalid data received from restraints control module

Dtc u0100 lost communication with ecm/pcm a

Other materials:

Combination meter display (color LCD)
WARNING When operating the combination meter display in your Subaru Ascent, always remain fully focused on safe driving conditions. Interacting with the display while the vehicle is moving can significantly reduce your attention to the road. If any adjustment or operation is required, it is s ...

Dtc b1409 scu communication
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1409 SCU COMMUNICATIONDTC detecting condition:Communication failure between body integrated unit and security control moduleCAUTION:When the body integrated unit is replaced, registration of the immobilizer sy ...

Installation
ENTERTAINMENT > Data Communication ModuleINSTALLATION1. DATA COMMUNICATION MODULECAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system compone ...