Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

POWER ASSISTED SYSTEM (POWER STEERING) > Steering Wheel

INSTALLATION

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

If the steering wheel and steering angle sensor are removed, perform the following VDC setting mode. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

Model without EyeSight: VDC sensor midpoint setting mode VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

Model with EyeSight: Neutral of Steering Angle Sensor & Lateral G Sensor 0 point setting VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

Model with EyeSight: Longitudinal G sensor & lateral G sensor 0 point setting VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

1. Align the center position of the roll connector. Roll Connector > ADJUSTMENT">

2. Install each part in the reverse order of removal.

NOTE:

Align the alignment marks on the steering wheel and the column assembly - steering.

Tightening torque:

Steering wheel: 39 N·m (3.98 kgf-m, 28.8 ft-lb)

Clearance:

Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in)

Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelINSPECTION1. PADDLE SHIFT SWITCHCheck the resistance of paddle switch.STEPCHECKYESNO1.SHIFT-UP SWITCH CONTINUITY CHECK.1) Operate the + side o ...

Universal joint
...

Other materials:

Dtc p2404 evap system leak detection pump sense circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2404 EVAP SYSTEM LEAK DETECTION PUMP SENSE CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, per ...

Assembly
MECHANICAL(H4DO) > Cam CarrierASSEMBLY1. CAM CARRIER RH1. Install the filter to the cam carrier RH.NOTE:Use a new filter.Filter insert position:Cam carrier RH end face 0+0 −0.5 mm (+0 −0.0197 in) position(A)0 — 0.5 mm (0 — 0.0197 in) 2. Set the intake camshaft RH and the exhaus ...

Inspection
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If the cable is faulty, replace the latch & actuator assembly - rear.2. ACTUATOR1. Check door lock operationCheck the door lock operation when battery voltage is applied ...

© 2016-2026 Copyright www.sucross.com