Subaru Crosstrek Service Manual: Installation
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof Motor
INSTALLATION
CAUTION:
• For installation of the stereo camera cover assembly, refer to “INSTALLATION”, “Stereo Camera” in the “EyeSight” section and observe the precautions for installation. Stereo Camera > INSTALLATION">
• When installing the motor assembly - sunroof, be careful not to move the cable assembly.
1. Install the motor assembly - sunroof.
2. Install the stereo camera cover assembly. (Models with EyeSight) Stereo Camera > INSTALLATION">
3. Install the light assembly - map. (Models without EyeSight)
4. Connect the battery ground terminal. NOTE">
5. Perform the initialize operation. Sunroof Control System > OPERATION">
6. Check the operation of sunroof by following the table below.
Operation | Switch position |
(1) Lid assembly - sunroof closes completely. | Close |
(2) Lid assembly - sunroof is tilted up to the top position. | Tilt up |
(3) Lid assembly - sunroof closes completely. | Tilt down |
(4) Lid assembly - sunroof opens 295 mm (11.61 in) away from completely closed position. | Open |
(5) Lid assembly - sunroof opens completely. | Open |
(6) Lid assembly - sunroof closes completely. | Close |
Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof MotorREMOVAL1. Completely close the lid assembly - sunroof.2. Disconnect the ground cable from battery. NOTE">3. Remove the light assembly ...
Sunroof switch
...
Other materials:
List
AIRBAG SYSTEM (DIAGNOSTICS) > Read Current DataLISTItemDisplayNoteTrip Count — — Count — — Time Count [msec] — — Belt Buckle Switch RHUnbelted/Belted“Belted” when passenger’s seat belt is fastened“Unbelted” when passenger’s seat belt is not faste ...
Headlight beam leveler (if equipped)
Automatic headlight beam leveler (models with
HID headlights)
The HID headlights generate more light
than conventional halogen headlights.
Therefore a driver of an oncoming vehicle
may experience too much glare if your
headlight beam height adjustment is high
when the vehicle is carrying a ...
Removal
STARTING/CHARGING SYSTEMS(H4DO) > BatteryREMOVAL1. Disconnect the positive (+) terminal after disconnecting the negative (−) terminal of battery.2. Remove the battery cable holder from the battery rod.3. Remove the flange nut from battery rod and remove battery holder.4. Remove the battery. ...
