SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof Motor
REMOVAL
1. Completely close the lid assembly - sunroof.
2. Disconnect the ground cable from battery. NOTE">
3. Remove the light assembly - map. (Models without EyeSight) Spot Map Light > REMOVAL">
4. Remove the stereo camera cover assembly. (Models with EyeSight) Stereo Camera > REMOVAL">
5. Remove the motor assembly - sunroof.
(1) Disconnect the harness connector.
(2) Remove the screws and remove the motor assembly - sunroof.
CAUTION:
When removing the motor assembly - sunroof, secure the cable assembly so that it does not move.

Inspection
InstallationInstallation
SEATS > Seat Heater SystemINSTALLATIONCAUTION:• If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.• When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the ho ...
Steering angle sensor Replacement
VEHICLE DYNAMICS CONTROL (VDC) > Steering Angle SensorREPLACEMENTCAUTION:• If the steering wheel and steering angle sensor are removed, perform the following VDC setting mode.– Model without EyeSight: VDC sensor midpoint setting mode VDC Control Module and Hydraulic Control Unit (VDCCM& ...
Dtc b2a07 backup battery charge system performance
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A07 BACKUP BATTERY CHARGE SYSTEM PERFORMANCEDIAGNOSIS START CONDITION:When ignition switch is ON.DTC DETECTING CONDITION:Backup battery is disconnected for at least 5 seconds when the ignition switch is ...