Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

SPEED CONTROL SYSTEMS(H4DO) > Accelerator Pedal

REMOVAL

1. Disconnect the ground cable from battery. NOTE">

2. Disconnect the connector (A).

3. Remove the nut (B) securing accelerator pedal assembly, and remove the accelerator pedal assembly.

Disassembly
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalDISASSEMBLYNOTE:The accelerator pedal cannot be disassembled. ...

Inspection
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalINSPECTION1. CHECK ACCELERATOR PEDAL SENSOR AREA (METHOD WITH CIRCUIT TESTER)1. Remove the glove box. Glove Box > REMOVAL">2. Turn the ign ...

Other materials:

Dtc p0102 mass or volume air flow sensor "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0102 MASS OR VOLUME AIR FLOW SENSOR "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving performance ...

Tilting moonroof
Raise Lower The tilting function is activated only when the moonroof is fully closed. To raise: Press the rear side of the "UP/DOWN" switch momentarily. The moonroof raises completely. To lower: Press and hold the front side of the "UP/ DOWN" switch until the preferred positi ...

Dtc p014c a/f / o2 sensor slow response - rich to lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P014C A/F / O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 1DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perfor ...

© 2016-2026 Copyright www.sucross.com