OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Clear Memory Mode
OPERATION
After repairing the occupant detection system, clear the DTCs stored in the airbag control module and the occupant detection control module.
1. AIRBAG SYSTEM
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Airbag» and select «Enter».
5. On «Airbag» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
2. OCCUPANT DETECTION SYSTEM
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Occupant Detection» and then select «Enter».
5. On «Occupant Detection» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
Check list for interview Check
Electrical component location LocationInspection
SECURITY AND LOCKS > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Check the resistance between relay terminals.Terminal No.Inspection con ...
Child safety locks
The Subaru Ascent is equipped with child safety locks on each rear door, providing
an additional level of protection for young passengers.
When the child safety lock lever is set to the "LOCK" position, the rear door
cannot be opened from the inside. It can only be opened from the ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission CaseINSTALLATION1. Clean the mating surface of transmission case and converter case.2. Select the reduction gear shim. Reduction Drive Gear > ADJUSTMENT">3. Remove the transmission case, and install the selected reduction gear s ...