Subaru Crosstrek Service Manual: Occupant detection system (diagnostics)
- Control module i/o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc b1650 occupant detection system malfunction
- Dtc b1655 front buckle switch rh failure
- Dtc b1760 occupant detection sensor mat
- Dtc b1761 occupant detection sensor mat liquid coating
- Dtc b1771 buckle switch
- Dtc b1795 occupant detection module internal circuit
- General description
- Subaru select monitor
- Airbag connector Procedure
- Airbag warning light illumination pattern Inspection
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Electrical component location Location
- Inspection mode Procedure
- List of diagnostic trouble code (dtc) List
- Passenger s airbag on/off indicator light illumination pattern Inspection
- Read current data Operation
- Read diagnostic trouble code (dtc) Operation
Preparation for overhaul Procedure
MECHANICAL(H4DO) > Preparation for OverhaulPROCEDURE1. After removing the engine from the vehicle body, attach the ST to the engine as shown in the figure.NOTE:When using a commercially sold engine ...
Other materials:
Installation
DIFFERENTIALS > Rear Differential Front MemberINSTALLATION1. Install the rear differential front member, and temporarily attach and tighten a new self-locking nut.2. Remove the transmission jack.3. Tighten the self-locking nut.Tightening torque:T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)T2: 110 N&m ...
General precautions regarding SRS airbag system
WARNING
To obtain maximum protection in
the event of an accident, the
driver and all passengers must
always wear seatbelts when in
the vehicle. The SRS airbag is
designed only to be a supplement
to the primary protection
provided by the seatbelt. It does
not eliminate the need to ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodINSTALLATION1. Install the check ball spring and check ball to the reverse fork rod arm, and press in the ST.ST 399411700ACCENT BALL INSTALLER2. Install the reverse fork rod through the hole on the rear of the transmission case. P ...
