Subaru Crosstrek Service Manual: Basic diagnostic procedure Procedure
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Basic Diagnostic Procedure
PROCEDURE
| STEP | CHECK | YES | NO |
1.CHECK WARNING LIGHT.
Check whether the airbag warning light in the combination meter is lit.
Does the airbag warning light illuminate?
Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.
Perform the diagnosis according to phenomenon of the problem.
2.READ DTC.
1) Turn the ignition switch to OFF.
2) Connect the Subaru Select Monitor to data link connector.
3) Turn the ignition switch to ON and run the Subaru Select Monitor.
4) Read the DTC. Read Diagnostic Trouble Code (DTC) > OPERATION">
NOTE:
If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Subaru Select Monitor > INSPECTION">
5) Record all DTCs and freeze frame data.
Is DTC displayed?
Basic Diagnostic Procedure > PROCEDURE">Go to Step 3.
Go to “Airbag Warning Light Failure” Airbag Warning Light Failure">.
3.PERFORM DIAGNOSIS.
1) Determine the possible cause from “List of Diagnostic Trouble Code (DTC)” List of Diagnostic Trouble Code (DTC)">.
2) Inspect the DTC using “List of Diagnostic Trouble Code (DTC)”.
3) Repair the trouble cause.
4) Perform the Clear Memory Mode. Clear Memory Mode">
5) Perform the Inspection Mode. Inspection Mode">
6) Read any other DTCs displayed.
Is DTC displayed?
Perform the procedure 1) to 5) in step 3.
Finish the diagnosis.
Airbag warning light illumination pattern Inspection
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Airbag Warning Light Illumination PatternINSPECTIONTurn the ignition switch to ON, and confirm that the airbag warning light remains on for approx. 6 secon ...
Check list for interview Check
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Check List for InterviewCHECK1. CONDITIONS OF MALFUNCTIONCustomer’s Name Inspector’s Name Date Vehicle Brought in/ /Registration No. ...
Other materials:
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSPECTION1. Check that the knock sensor has no deformation, cracks or other damages.2. Measure the resistance between knock sensor terminals.Terminal No.Standard1 and 2560±28 k? ...
Repair
EXTERIOR/INTERIOR TRIM > Front BumperREPAIR1. COATING METHOD FOR PP BUMPERProcess No.Process nameJob contents1Bumper installationPlace the bumper on a paint worktable as required. Use the paint worktable conforming to inner shape of bumper if possible.Cross section of bumper(1) Bumper(2) Paint wo ...
Dtc c1521 motor relay
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1521 MOTOR RELAYDTC detecting condition:• Defective motor and motor relay• Defective harness connectorTrouble symptom:• ABS does not operate.• VDC does not operate.&b ...
