Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b1760 occupant detection sensor mat

OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC B1760 OCCUPANT DETECTION SENSOR MAT

Diagnosis start condition:

Ignition voltage is 8 V to 16 V.

DTC detecting condition:

• Occupant detection sensor is faulty.

• Occupant detection sensor circuit is open, shorted between terminals, shorted to power supply or shorted to ground.

• Seat heater circuit is open.

• Occupant detection control module is faulty.

STEPCHECKYESNO

1.CHECK POOR CONTACT OF CONNECTORS.

Check for poor contact of connectors between the occupant detection control module and the occupant detection sensor.

Is there poor contact of connector?

When the connector is not fully connected, reconnect the connector correctly. Replace the faulty harness if the connector is faulty. (Replace the occupant detection harness or replace the occupant detection system (passenger’s & frame assembly)). Front Seat > DISASSEMBLY">

Replace the occupant detection system (passenger’s & frame assembly). Front Seat > DISASSEMBLY">

Dtc b1655 front buckle switch rh failure
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1655 FRONT BUCKLE SWITCH RH FAILUREDiagnosis start condition:Ignition voltage is 8 V to 16 V.DT ...

Dtc b1761 occupant detection sensor mat liquid coating
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1761 OCCUPANT DETECTION SENSOR MAT LIQUID COATINGDIAGNOSIS START CONDITION:Ignition voltage is ...

Other materials:

List of diagnostic trouble code (dtc) List
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LIST(1) Keyless access systemDTCItemContent of diagnosisNoteU0073CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected. Diagnostic Procedure with Diagnostic Trouble Code ...

Removal
GLASS/WINDOWS/MIRRORS > Outer Mirror AssemblyREMOVALRefer to “DISASSEMBLY” for removal procedures of scalp cap and mirror face. Outer Mirror Assembly > DISASSEMBLY">1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE&quo ...

Basic diagnostic procedure Procedure
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURENOTE:When the sunload sensor check is performed indoors or in the shade, it could be diagnosed as sensor having an open circuit. Always perform the inspection in direct sunlight.STEPCHECKYESNO1.START INSPECTIONS.1) Prepare ...

© 2016-2026 Copyright www.sucross.com