Subaru Crosstrek Service Manual: Dtc b1761 occupant detection sensor mat liquid coating

DIAGNOSIS START CONDITION:

Ignition voltage is 8 V to 16 V.

DTC DETECTING CONDITION:

• Occupant detection sensor is spattered with fluid.

• Occupant detection sensor is faulty.

• Occupant detection control module is faulty.

1.DRY THE SEAT.

1) Open the vehicle windows in a well-ventilated place indoors and dry the seat for 24 hours.

2) Check that the seat is not wet. If the seat is wet, extend the drying time to dry the seat well.

3) Read the DTC of the occupant detection system. Read Diagnostic Trouble Code (DTC) > OPERATION">

Is DTC detected?

When DTC B1761 is detected again, replace the occupant detection system (passenger’s & frame assembly). Front Seat > DISASSEMBLY">

When any other DTC is detected, perform the diagnosis according to the DTC.

Clear the memory. Clear Memory Mode > OPERATION">

Dtc b1760 occupant detection sensor mat

Dtc b1771 buckle switch

Other materials:

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorINSPECTION1. CRANKSHAFT POSITION SENSOR (METHOD WITH OSCILLOSCOPE)1. Prepare an oscilloscope.2. Remove the glove box. Glove Box > REMOVAL">3. Connect the probe to ECM connector.Terminal No.Probe16+1−4. Start the eng ...

Anniversary setting
1. Perform the preparation steps according to "Preparation for date setting" 3- 56. 2. Operate the " " or "  " switch to select the "Anniversary" item. Then push the button. 3. Select an entry in the list to set by operating the " " or " " switch. Then push the  ...

Adjustment
POWER ASSISTED SYSTEM (POWER STEERING) > Electric Power Steering GearboxADJUSTMENT1. GEARBOX BACKLASH ADJUSTMENT1. Remove the steering gearbox assembly. Electric Power Steering Gearbox > REMOVAL">2. Loosen the lock nut and adjusting screw.3. Apply a coat of grease to the sliding surfa ...