Subaru Crosstrek Service Manual: Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension Case
REMOVAL
1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">
2. Remove the extension case and transmission hanger.
NOTE:
The total number of extension case mounting bolts is 13.
3. Remove the O-ring.
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseADJUSTMENTNOTE:When replacing the extension case, select the transfer drive gear shim and transfer driven gear shim. Reduction Drive Gear ...
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseASSEMBLY1. Press-fit the dust cover into extension case.2. Install the extension case oil seal to extension case. Differential Side Retain ...
Other materials:
Basic diagnostic procedure Procedure
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:Before removal or installation, be sure to remove any foreign matter (dust, moisture, oil, etc.) from the TPMS & keyless entry CM connector or TPMS CM connector.NOTE:To check harness for open or short c ...
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Purge Control Solenoid ValveREMOVAL1. Disconnect the ground cable from battery.2. Remove the bolt which holds the purge control solenoid valve onto intake manifold.NOTE:Hold the purge control solenoid valve unit by hand to prevent it from r ...
Where to place a child restraint system
The following are SUBARU's recommendations
on where to place a child restraint
system in your vehicle.
A: Front passenger's seat
You should not install a child restraint
system (including a booster seat) due to
the hazard to children posed by the
passenger's airbag.
B: Rear seat, window- ...
