Subaru Crosstrek Service Manual: Preparation for overhaul Procedure
MECHANICAL(H4DO) > Preparation for Overhaul
PROCEDURE
1. After removing the engine from the vehicle body, attach the ST to the engine as shown in the figure.
NOTE:
When using a commercially sold engine stand, follow the instructions of engine stand used.
Tightening torque:
35 N·m (3.6 kgf-m, 25.8 ft-lb)
| ST1 498457000 | ENGINE STAND ADAPTER RH |
| ST2 498457100 | ENGINE STAND ADAPTER LH |
| ST3 18362AA020 | ADAPTER |
| ST4 499817100 | ENGINE STAND |
2. In this section the procedures described under each index are all connected and stated in order. The procedure for overhauling of the engine will be completed when you go through all steps in the process.
Therefore, in this section, to conduct the particular procedure within the flow of a section, you need to go back and conduct the procedure described previously in order to do that particular procedure.
Piston Specification
MECHANICAL(H4DO) > PistonSPECIFICATIONRefer to “Cylinder Block” for removal and installation procedures of pistons. Cylinder Block > REMOVAL"> Cylinder Block > INSTALLAT ...
Other materials:
Installation
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyINSTALLATION1. Before installation, check the following items.• Rod is free from deformation.• Grease is applied sufficiently to rod joints.If grease is insufficient, add it as necessary before assembling the rod.&bu ...
Replacement
LUBRICATION(H4DO) > Engine OilREPLACEMENTCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.1. Turn the ignition switch to OFF.2. Open the oil filler cap for quick draining of engine oil.3. Lift up the vehicle. ...
Dtc b2282 vehicle speed signal correlation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2282 VEHICLE SPEED SIGNAL CORRELATIONDTC detecting condition:When the vehicle speed signal transmitted from VDC via solid line and the vehicle speed signal transmitted via CAN ...
