Subaru Crosstrek Service Manual: Piston Specification
MECHANICAL(H4DO) > Piston
SPECIFICATION
Refer to “Cylinder Block” for removal and installation procedures of pistons. Cylinder Block > REMOVAL">
Cylinder Block > INSTALLATION">
Intake manifold vacuum Inspection
MECHANICAL(H4DO) > Intake Manifold VacuumINSPECTION1. Turn the ignition switch to OFF.2. Warm up the engine.3. Install the vacuum gauge.(1) Remove the brake booster vacuum hose from the intake mani ...
Preparation for overhaul Procedure
MECHANICAL(H4DO) > Preparation for OverhaulPROCEDURE1. After removing the engine from the vehicle body, attach the ST to the engine as shown in the figure.NOTE:When using a commercially sold engine ...
Other materials:
Component
VEHICLE DYNAMICS CONTROL (VDC) > General DescriptionCOMPONENT1. ABS WHEEL SPEED SENSOR(1)Front ABS wheel speed sensor(4)Rear ABS wheel speed sensorTightening torque: N·m (kgf-m, ft-lb)(2)Housing ASSY - front axle(5)Magnetic encoderT1:7.5 (0.8, 5.5)(3)Housing ASSY - rear axle(6)Hub unit COM ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > EvaporatorINSTALLATIONCAUTION:• If the evaporator assembly - cooling has been replaced, add an appropriate amount of compressor oil. Compressor Oil > ADJUSTMENT">• When the evaporator assembly - cooling has been replaced, replace ...
Electronic parking brake
Parking brake switch
Indicator light
Release the electronic parking brake
Apply the electronic parking brake
WARNING
Before leaving your Subaru Ascent, always make sure the engine is completely
turned off.
If the engine remains on, the electronic parking brake could relea ...
