Subaru Crosstrek Service Manual: Mechanical(h4do)
- Cam carrier
- Cam clearance
- Cam sprocket
- Camshaft
- Chain cover
- Crank pulley
- Crank sprocket
- Cylinder block
- Cylinder head
- Engine assembly
- Engine mounting
- General description
- Rocker cover
- Timing chain assembly
- V-belt
- Compression Inspection
- Connecting rod Specification
- Crankshaft Specification
- Engine noise Inspection
- Engine oil pressure Inspection
- Engine trouble in general Inspection
- Fuel pressure Inspection
- Idle speed Inspection
- Ignition timing Inspection
- Intake and exhaust valve Specification
- Intake manifold vacuum Inspection
- Piston Specification
- Preparation for overhaul Procedure
Preparation for overhaul Procedure
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Preparation for OverhaulPROCEDURE1. Clean oil, grease, dirt and dust from the transmission.2. When transmission gear oil remains in the transmission, usi ...
Cam carrier
...
Other materials:
Removal
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the arm assembly - rear wiper.(1) Remove the cover - rear wiper arm.(2) Remove the nut, and remove the ...
Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Stopper
2. Remove the wiper blade assembly by
holding its pivot area and pushing it in the
direction shown by the arrow while depressing
the wiper blade stopper.
3. Install the wiper blade assembly to the
wiper arm. Make sure that it locks i ...
Adjustment
CLUTCH SYSTEM > Clutch SwitchADJUSTMENT1. Loosen the lock nut of the clutch start switch.(A)Lock nut(B)Clutch start switch2. Disconnect the harness connector of the clutch start switch.3. Remove the snap pin and clevis pin connecting the clutch pedal and operating rod.(A)Clevis pin(B)Snap pin(C)P ...
