Subaru Crosstrek Service Manual: Crank sprocket

Installation

MECHANICAL(H4DO) > Crank PulleyINSTALLATION1. Degrease the press-fit section for the chain cover front oil seal, and install the front oil seal to the chain cover using ST.CAUTION:Do not apply flui ...

Inspection

MECHANICAL(H4DO) > Crank SprocketINSPECTION1. Check the crank sprocket teeth for abnormal wear and scratches.2. Make sure there is no free play between crank sprocket and key. ...

Other materials:

Removal
EXTERIOR/INTERIOR TRIM > Roof SpoilerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR. Rear Gate Trim > REMOVAL">3. Remove the roof spoiler assembly.(1) Disconnect the connector of high-mounted stop light.(2) Remove the caps, ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorINSTALLATIONCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.• After installing the secondary speed sensor, adjust t ...

Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...