Subaru Crosstrek Service Manual: Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed Sensor
INSTALLATION
CAUTION:
• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.
• After installing the secondary speed sensor, adjust the CVTF level.
Install in the reverse order of removal.
NOTE:
• Use new O-rings.
• Apply CVTF to the O-ring.
Tightening torque:
7 N·m (0.7 kgf-m, 5.2 ft-lb)
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorREMOVALCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesio ...
Other materials:
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission CaseINSTALLATION1. Wipe off grease, oil and dust on the mating surfaces of transmission cases with cleaning solvent.2. Install the reverse idler gear. Reverse Idler Gear > INSTALLATION">3. Install the shifter fork and rod. Shif ...
Dtc c1311 fr hold valve
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1311 FR HOLD VALVENOTE:For the diagnostic procedure, refer to “DTC C1362 NORMAL CLOSING VALVE 2”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1362 NORMAL C ...
Rear combination lights
1. Using a Phillips screwdriver, remove
the upper and lower screws that secure
the rear combination light assembly.
2. Slide the rear combination light as-
11-38
sembly rearward and remove it from the
vehicle.
Rear side marker light
Rear turn signal light
Backup light
Sto ...
