Subaru Crosstrek Service Manual: Intake and exhaust valve Specification
MECHANICAL(H4DO) > Intake and Exhaust Valve
SPECIFICATION
Refer to “Cylinder Head” for removal and installation procedures of the intake and exhaust valves. Cylinder Head > REMOVAL">
Cylinder Head > INSTALLATION">
Ignition timing Inspection
MECHANICAL(H4DO) > Ignition TimingINSPECTIONCAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement.1. Before checking the ignition timing, check the follo ...
Intake manifold vacuum Inspection
MECHANICAL(H4DO) > Intake Manifold VacuumINSPECTION1. Turn the ignition switch to OFF.2. Warm up the engine.3. Install the vacuum gauge.(1) Remove the brake booster vacuum hose from the intake mani ...
Other materials:
Inspection
LIGHTING SYSTEM > Light Control SensorINSPECTION1. Turn the ignition switch to ON.2. Set the lighting switch to AUTO position.3. Check the voltage between the sensor terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardConnection diagram2 (+) — 1 (−)Measure th ...
Driver Monitoring System
The Driver Monitoring System, known in some markets as DriverFocus, is an advanced
safety and personalization feature integrated into the Subaru Ascent. This intelligent
system continuously observes the driver’s behavior to detect signs of distraction
or reduced attention, while also identif ...
Operating range for push-button start system
Antenna
Operating range
NOTE
If the access key is not detected
within the operating range of the antennas
inside the vehicle, the pushbutton
ignition switch and the engine
start cannot be operated.
Even when the access key is outside
the vehicle, if it is placed too close to
the ...
