Subaru Crosstrek Service Manual: Ignition timing Inspection
MECHANICAL(H4DO) > Ignition Timing
INSPECTION
CAUTION:
After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement.
1. Before checking the ignition timing, check the following item:
(1) Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly.
(2) Check the malfunction indicator light does not illuminate.
2. Warm up the engine.
3. Read the ignition timing using Subaru Select Monitor. Subaru Select Monitor > OPERATION">
NOTE:
If ignition timing is out of standard, check the ignition control system. Refer to “Engine Control System”. Basic Diagnostic Procedure">
Ignition timing [BTDC/{r/min}]:
Standard
16°±10°/650 (CVT model)
12°±10°/650 (MT model)
Idle speed Inspection
MECHANICAL(H4DO) > Idle SpeedINSPECTION1. Before checking the idle speed, check the following item:(1) Check the air cleaner element is free from clogging, ignition timing is correct, spark plugs a ...
Intake and exhaust valve Specification
MECHANICAL(H4DO) > Intake and Exhaust ValveSPECIFICATIONRefer to “Cylinder Head” for removal and installation procedures of the intake and exhaust valves. Cylinder Head > REMOVAL&qu ...
Other materials:
Clock/calendar screen
Clock (analog format)
Clock (digital format)
Calendar
Today's date
Birthday/Anniversary
In addition to the clock/calendar, the outside
temperature and average fuel consumption
can also be displayed.
You can select clock (analog format),
clock (digital format) or calendar ...
Disassembly
BRAKE > Master CylinderDISASSEMBLY1. Remove the reservoir tank.CAUTION:Be careful not to tighten a vise excessively.(1) Place the master cylinder assembly between aluminum plates and fix it on a vise.(2) Drive out the pin using a punch and a hammer to remove the reservoir tank.2. Remove the seal ...
Operation
EyeSight (DIAGNOSTICS) > Diagnostic Code(s) DisplayOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, select ...
