Subaru Crosstrek Service Manual: Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR Control Valve
INSPECTION
1. Check that the EGR control valve has no deformation, cracks or other damages.
2. Measure the resistance between EGR control valve terminals.
Terminal No. | Standard |
2 and 1 | 22±2 ? |
2 and 3 | 22±2 ? |
5 and 4 | 22±2 ? |
5 and 6 | 22±2 ? |
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR Control ValveREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) ...
Other materials:
Oil pressure warning light
If
this light illuminates when the engine is
running, it may indicate that the engine oil
pressure is low and the lubricating system
is not working properly.
If the light illuminates while driving or does
not turn off after the engine starts, stop the
engine at the first safe opportunity ...
MT models
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Depress the clutch pedal to the floor
and shift the shift lever into neutral. Hold
the clutch pedal to the floor while starting
the engine.
The starter motor will only operate when
the clutch pedal is depress ...
Dtc b2903 vdc data error
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2903 VDC DATA ERRORDTC DETECTING CONDITION:Detected when data (vehicle speed signal) from VDC CM is abnormal.TROUBLE SYMPTOM:The auto headlight beam leveler does not operate.NOTE:Perform ...
