Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b2903 vdc data error

AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC B2903 VDC DATA ERROR

DTC DETECTING CONDITION:

Detected when data (vehicle speed signal) from VDC CM is abnormal.

TROUBLE SYMPTOM:

The auto headlight beam leveler does not operate.

NOTE:

Perform the diagnosis for VDC. Basic Diagnostic Procedure > PROCEDURE">

Dtc u0122 lost communication with vehicle dynamics control module
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULEDetected when CAN data (ve ...

Dtc u0140 lost communication with body control module
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0140 LOST COMMUNICATION WITH BODY CONTROL MODULEDetected when CAN data (headlights ON ...

Other materials:

Inspection mode Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Inspection ModePROCEDUREPerform the diagnosis shown in the following DTC table.When performing the diagnosis not listed in “List of Diagnostic Trouble Code (DTC)”, refer to the item on the drive cycle. Drive Cycle">DTCItemConditionB1570ANTENNA — ...

New vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your vehicle are dependent on how you handle and care for your vehicle while it is new. Follow these instructions during the first 1,000 miles (1,600 km): Do not race the engine. And do not allow engine speed to exceed 4,000 rpm except in an emergency ...

Interior light system Wiring diagram
WIRING SYSTEM > Interior Light SystemWIRING DIAGRAM1. WITHOUT EyeSight2. WITH EyeSight ...

© 2016-2026 Copyright www.sucross.com