Subaru Crosstrek Service Manual: Auto headlight beam leveler system (diagnostics)
- Control module i/o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc b2903 vdc data error
- Dtc u0140 lost communication with body control module
- Dtc b2900 ahl control
- Dtc b2902 rear height sensor circuit
- Dtc u0073 control module communication bus off
- General description
- Read current data
- Subaru select monitor
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Diagnostics with phenomenon Inspection
- Electrical component location Location
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
Inspection locations after a collision Inspection
AIRBAG SYSTEM > Inspection Locations after a CollisionINSPECTIONIf the vehicle is involved in a collision, even if it is a slight collision, be sure to check the following systems.1. DRIVER’S ...
Other materials:
Dtc b1795 occupant detection module internal circuit
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1795 OCCUPANT DETECTION MODULE INTERNAL CIRCUITDIAGNOSIS START CONDITION:Ignition voltage is 8 V to 16 V.DTC DETECTING CONDITION:Occupant detection control module is faulty.When “DTC B1795 ...
Adjustment
CONTROL SYSTEMS > Select CableADJUSTMENT1. Shift the select lever to “N” range.2. Lift up the vehicle.3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">4. Remove the center exhaust cover.5. Loosen the adjusting nuts on both sides.(A)Adjusting nut A(B)Adjust ...
Removal
SECURITY AND LOCKS > Rear Outer HandleREMOVAL1. Raise the glass assembly - rear door to the top position.2. Disconnect the ground cable from battery. NOTE">3. Remove the trim panel - rear door. Door Trim > REMOVAL">4. Remove the sealing cover - rear door. Rear Sealing Cover ...
