Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Operation

AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Subaru Select Monitor

OPERATION

For detailed operation procedures, refer to “Application help”.

If the auto headlight beam leveler CM can not communicate with Subaru Select Monitor, perform “COMMUNICATION FOR INITIALIZING IMPOSSIBLE”. Subaru Select Monitor > INSPECTION">

Inspection
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLECommunication error with auto headlight beam leveler CMDetecting condit ...

Basic diagnostic procedure Procedure
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the condition o ...

Other materials:

Dtc c0027 rear left abs sensor circuit open or short
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0027 REAR LEFT ABS SENSOR CIRCUIT OPEN OR SHORTDTC detecting condition:• Defective ABS wheel speed sensor (broken wire, input voltage too high)• Defective harness connectorTroubl ...

Dtc p0128 coolant thermostat (engine coolant temperature below thermostat regulating temperature)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0128 COOLANT THERMOSTAT (ENGINE COOLANT TEMPERATURE BELOW THERMOSTAT REGULATING TEMPERATURE)DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Thermo ...

Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear ...

© 2016-2025 Copyright www.sucross.com