Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Wiring diagram

AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Control Module I/O Signal

WIRING DIAGRAM

Refer to “Headlight Beam Leveler System” in the wiring diagram. Headlight Beam Leveler System > WIRING DIAGRAM">

Electrical specification
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION1. AUTO HEADLIGHT BEAM LEVELER CMContentTerminal No.Measuring conditionStandardIG power supply1 & ...

Diagnostic procedure with diagnostic trouble code (dtc)
...

Other materials:

Removal
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD)REMOVAL1. MULTI FUNCTION DISPLAY1. Disconnect the ground cable from battery. NOTE">2. Remove the center grille assembly. Air Vent Grille > REMOVAL">3. Release the claw and hook, and then remove the cover center UPR.NOT ...

Dtc p0031 a/f / o2 heater control circuit low bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0031 A/F / O2 HEATER CONTROL CIRCUIT LOW BANK 1 SENSOR 1DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...

Removal
SECURITY AND LOCKS > Impact SensorREMOVAL1. Pull out the key from the ignition switch, or turn off the power.2. Close all the doors and rear gate.3. Press the UNLOCK button of the keyless transmitter or access key.4. Disconnect the ground cable from battery. NOTE">5. Remove the impact se ...

© 2016-2026 Copyright www.sucross.com