Subaru Crosstrek Owners Manual: Alarm system
The alarm system helps to protect your vehicle and valuables from theft. The horn sounds and the hazard warning flashers flash if someone attempts to break into your vehicle.
For models with "keyless access with push-button start system": The system can be armed or disarmed with the keyless access function or access key.
The system will not be activated when the push-button ignition switch is in the "ACC" or "ON" position.
For models without "keyless access with push-button start system": The system can be armed or disarmed with the remote transmitter.
The system will not be activated when the key is inserted into the ignition switch.
Your vehicle's alarm system has been set for activation at the time of shipment from the factory. You can set the system for deactivation yourself or have it done by your SUBARU dealer.
- System operation
- Activating and deactivating the alarm system
- If you have accidentally triggered the alarm system
- Arming the system
- Disarming the system
- Valet mode
- Passive arming (models without "keyless access with push-button start system")
- Tripped sensor identification
- Shock sensors (dealer option)
Certification for remote keyless entry system
U.S.-spec. models
FCC ID: CWTWB1U811
FCC ID: CWTWD1U781
CAUTION
FCC WARNING
Changes or modifications not expressly
approved by the party responsible
for compliance could void
the user's author ...
System operation
The alarm system will sound the following
alarms when triggered.
The vehicle's horn will sound for 30
seconds.
The hazard warning flashers will flash
for 30 seconds.
If any of the doors ...
Other materials:
Adjustment
WIPER AND WASHER SYSTEMS > Rear Wiper ArmADJUSTMENT1. Operate the rear wiper once.2. Align the blade assembly - rear wipe with the marking on the glass.3. If the wiper blade is not aligned with the point mark, perform the removal of the rear wiper to align with the marking. Rear Wiper Arm > R ...
Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Subaru Select MonitorOPERATION• For detailed operation procedures, refer to “Application help”.• When the radar sensor cannot communicate with Subaru Select Monitor, perform “COMMUNICATION FOR INITIALIZING ...
Removal
COOLING(H4DO) > Water Pipe AssemblyREMOVAL1. WATER PIPE ASSEMBLY RH1. Disconnect the ground cable from battery. NOTE">2. Drain engine coolant. Engine Coolant > REPLACEMENT">3. Remove the front exhaust pipe. Front Exhaust Pipe > REMOVAL">4. Disconnect the water hos ...
