Subaru Crosstrek Owners Manual: Disarming the system

Perform either of the following procedures.

Briefly press the disarm button (for less than 2 seconds) on the access key/remote transmitter.

Carry the access key and perform either of the following procedures (models with "keyless access with push-button start system").

• Grip the front door handle.
• Press the rear gate opener button.

The following door(s) will unlock, an electronic chirp will sound twice and the hazard warning flashers will flash twice.

Driver's door: when either of the following procedures is performed

• Press the disarm button on the access key/remote transmitter briefly (for less than 2 seconds).
• Grip the driver's door handle (models with "keyless access with pushbutton start system").

Rear gate: when pressing the rear gate opener button (models with "keyless access with push-button start system")

All doors: when gripping the front passenger's door handle (models with "keyless access with push-button start system")

The flashing of the security indicator light will then change slowly (once approximately every 3 seconds from twice approximately every 2 seconds), indicating that the alarm system has been disarmed.

To unlock all other doors and the rear gate, briefly press the disarm button a second time within 5 seconds.

Emergency disarming

If you cannot disarm the system using the access key/transmitter (i.e. the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the access key/remote transmitter.

The system can be disarmed if you turn the ignition switch from the "LOCK"/"OFF" to the "ON" position with a registered key/ access key.

NOTE

For models with "keyless access with push-button start system", if the access key battery is discharged, perform the procedure described in "Switching power status" 9-17. In such a case, replace the battery immediately. Refer to "Replacing battery of access key" 11-42.