Subaru Crosstrek Owners Manual: Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and rear gate and panic activation.
To enter the valet mode, change the setting of your vehicle's alarm system for deactivation mode. Refer to "Activating and deactivating the alarm system" 2- 27. The security indicator light will continue to flash once every 3 seconds indicating that the system is in the valet mode.
To exit valet mode, change the setting of your vehicle's alarm system for activation mode. Refer to "Activating and deactivating the alarm system" 2-27.
Disarming the system
Perform either of the following procedures.
Briefly press the disarm button (for less
than 2 seconds) on the access key/remote
transmitter.
Carry the access key and perform
either of the followin ...
Passive arming (models without "keyless access with push-button start
system")
Passive arming mode
When passive arming mode has been
programmed by the dealer, arming of the
system is automatically accomplished
without using the remote transmitter. Note
that in this mode, DO ...
Other materials:
Removal
CLUTCH SYSTEM > Release Bearing and LeverREMOVAL1. Remove the transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the two clips from the release lever and remove the release bearing.CAUTION:Be careful not to deform the clips.3. Remove the dust cove ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorREMOVALCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.• When secondary speed sensor is removed, CVTF leaks. After ...
Dtc b28b3 stereo camera low temperature
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28B3 STEREO CAMERA LOW TEMPERATUREDetected when the temperature of the stereo camera excessively decreases.NOTE:When this DTC is detected, performing adjustment or inspection of the camera will not return to the ...
