Subaru Crosstrek Service Manual: Removal
CLUTCH SYSTEM > Release Bearing and Lever
REMOVAL
1. Remove the transmission assembly from the vehicle.
Manual Transmission Assembly > REMOVAL">
2. Remove the two clips from the release lever and remove the release bearing.
CAUTION:
Be careful not to deform the clips.
3. Remove the dust cover.
(A) | Release lever |
(B) | Dust cover |
4. Remove the attachment point of lever spring by inserting a screwdriver through the clutch housing release lever hole. Then remove the release lever.
(A) | Release lever |
(B) | Screwdriver |
Inspection
CLUTCH SYSTEM > Release Bearing and LeverINSPECTION1. RELEASE BEARINGCAUTION:Since this bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or any other solvent when s ...
Installation
CLUTCH SYSTEM > Release Bearing and LeverINSTALLATIONNOTE:Apply the specified grease to lubricate to the following points before installation.• Contact surface of lever and pivot• Conta ...
Other materials:
Electrical component location Location
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Steering gearbox(3)STEERING warning light(5)VDCCM&H/U(2)Power steering control module(4)Engine control module (ECM)(6)Data link connector (for Subaru Select Monitor)• U5 and U6 models• C ...
Battery drainage prevention function
If a door or the rear gate is not completely
closed, the interior lights will remain
illuminated as a result. However, several
lights are automatically turned off by the
battery drainage prevention function to
prevent the battery from discharging. The
following interior lights are affected by ...
Dtc p0685 ecm/pcm power relay control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0685 ECM/PCM POWER RELAY CONTROL CIRCUIT/OPENDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...
