Subaru Crosstrek Service Manual: Inspection
CLUTCH SYSTEM > Release Bearing and Lever
INSPECTION
1. RELEASE BEARING
CAUTION:
Since this bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or any other solvent when servicing the clutch.
1. Check the bearing for smooth movement by applying force to the bearing in the radial direction.
Radial direction stroke:
1.4 mm (0.055 in) or more
(A) | Bearing case |
2. While applying force to the bearing in the rotational direction, check the bearing for smooth rotation.
(A) | Bearing case |
3. Check for wear and damage at the bearing case surface in contact with the lever.
2. RELEASE LEVER
Check the pivot portion of the lever and the contact area with the release bearing case for wear.
(A) | Release lever |
(B) | Pivot |
(C) | Release bearing |
Removal
CLUTCH SYSTEM > Release Bearing and LeverREMOVAL1. Remove the transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the two clips from the release lev ...
Other materials:
Assembly
CLUTCH SYSTEM > Master CylinderASSEMBLY1. Apply a coat of grease to the contact surfaces of the push rod and piston before installation.Grease:SILICONE GREASE G-40M or equivalent2. Assemble in the reverse order of disassembly.Tightening torque:10 N·m (1.0 kgf-m, 7.4 ft-lb) ...
Read cancel code Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Read Cancel CodeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Selec ...
Removal
LUBRICATION(H4DO) > Engine Oil FilterREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.1. OIL FILTER1. Turn the ignition switch to OFF.2. Remove the oil filter.NOTE:Clean off water or dust from the oil ...
