Subaru Crosstrek Service Manual: Release bearing and lever

Installation

CLUTCH SYSTEM > Operating CylinderINSTALLATION1. Install in the reverse order of removal.NOTE:• Before installing the operating cylinder, apply grease to the contact point of the release leve ...

Inspection

CLUTCH SYSTEM > Release Bearing and LeverINSPECTION1. RELEASE BEARINGCAUTION:Since this bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or any other solvent when s ...

Other materials:

Remote start safety features
For safety and security reasons, the remote engine start system will prevent starting (or stop the engine if running) and sound the horn twice if any of the following conditions is detected. In addition, the fob will flash and beep 3 times. The brake pedal is depressed A key is in the ign ...

Driving tips
Always apply the foot or parking brake when the vehicle is stopped in the "D" or "R" position. Make sure to apply the parking brake when parking your vehicle. Do not hold the vehicle with only the mechanical friction of the transmission. Do not keep the vehicle in a stationary pos ...

Removal
EXTERIOR BODY PANELS > Front Sealing CoverREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the trim panel - front door. Door Trim > REMOVAL">3. Remove the sealing cover - front door.CAUTION:• Caref ...