Subaru Crosstrek Service Manual: Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Pressure Sensor
INSPECTION
1. Start and warm up the engine.
2. Depress the brake pedal, and shift the select lever to “D” range.
3. Shift the select lever to “P” or “N” range.
4. Depress the brake pedal and hold it.
5. Check «secondary pressure sensor voltage» by using Subaru Select Monitor while the engine is idling. Subaru Select Monitor > OPERATION">
Standard
Approx. 0.8 V
6. Check «secondary pressure sensor voltage» by using Subaru Select Monitor while the engine is stopped and the ignition switch is turned on. Subaru Select Monitor > OPERATION">
Specification:
Approx. 0.5 V
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Pressure SensorREMOVALCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If a ...
Other materials:
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven GearREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the extension case. Extension Case > REMOVAL">3. Remove the transfer clutch assembly. Transfe ...
Dtc p2195 a/f /o2 sensor signal biased/stuck lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2195 A/F /O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Cle ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Intake ManifoldREMOVAL1. Release the fuel pressure. Fuel > PROCEDURE">2. Disconnect the ground cable from battery.3. Open the fuel filler lid and remove the fuel filler cap.NOTE:This operation is required to release the inner pressure of the fuel ...
