Subaru Crosstrek Service Manual: Inspection
BRAKE > Rear Brake Pad
INSPECTION
1. Check the pad thickness.
NOTE:
• Always replace the pads of both wheels and both sides as a set.
• Replace pad clips if they are twisted or worn.
• Replace the pad if there is oil or grease on it.
• A wear indicator is installed on the pad - disc brake rear inner. If the pad is worn to the limit, the end of wear indicator contacts disc rotor, and a squeaking sound is heard as the wheel rotates. If the sound is heard, replace the pad.
Disc rotor type | Standard (A) | Wear limit (B) | |
Pad thickness | Solid | 9 mm (0.35 in) | 1.5 mm (0.059 in) |
2. If the wear limit is exceeded in the inspection, replace the brake pad.
Rear brake pad
...
Removal
BRAKE > Rear Brake PadREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the rear brake pad.(1) Remove the bolts and remove the brake hose bracket.(2) Remove the caliper bolt, ...
Other materials:
Function settings
A SUBARU dealer can change the settings of the functions shown in the
following table to meet your personal requirements. Contact
the nearest SUBARU dealer for details. If your vehicle is equipped with a multi
function display, the settings for some of these functions
can be changed using the ...
Installation
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse order of removal.Tightening torqueGarnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 f ...
Installation
LIGHTING SYSTEM > Rear Height SensorINSTALLATION1. Install each part in the reverse order of removal.Tightening torque:Sensor assembly - headlight beam leveler: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)Rear wheel: Except for C4 model120 N·m (12.24 kgf-m, 88.5 ft-lb)Rear wheel: C4 model100 N&m ...
