Subaru Crosstrek Service Manual: Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft Assembly
INSPECTION
• Make sure that all component parts are free of scratches, holes and other faults.
• Check the tooth contact. Drive Pinion Shaft Assembly > ADJUSTMENT">
• Apply CVTF to bearing and rotate the bearing to check for noise or dragging etc.
• Check the starting torque of drive pinion shaft.
CAUTION:
Before measuring, apply differential gear oil to roller of bearing and rotate the bearing several times.
| ST1 498937110 | HOLDER |
| ST2 499787700 | WRENCH |
Starting torque:
5.1 — 17.1 N (0.5 — 1.7 kgf, 1.1 — 3.8 lbf)
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyDISASSEMBLY1. Flatten the tab of the lock nut.2. Using ST1, ST2 and ST3, fix at the spline portion of drive pinion shaft to re ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyINSTALLATION1. Clean the mating surface of drive pinion retainer and converter case.2. Adjust the backlash and tooth contact b ...
Other materials:
Dtc c1732 lateral g sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1732 LATERAL G SENSORDTC detecting condition:Defective lateral G sensorTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.ST ...
Inspection
SECURITY AND LOCKS > Keyless TransmitterINSPECTION1. KEYLESS TRANSMITTER BATTERY1. Check the keyless transmitter battery voltage.PREPARATION TOOL:Circuit testerNOTE:Complete the measurement within 5 seconds because the battery discharges during measurement.Battery terminalInspection ConditionsSta ...
Installation
EXTERIOR BODY PANELS > Front DoorINSTALLATION1. FRONT DOOR PANEL1. Put a wooden block on a jack and place the panel assembly - front door on it.2. Apply grease to the sliding area of door hinges, and install the door hinge to vehicle.3. Adjust the height by the jack, and temporarily install the p ...
