Subaru Crosstrek Owners Manual: If you have accidentally triggered the alarm system
To stop the alarm
Do any of the following operations
- Press any button on the access key/ remote transmitter.
- Turn the ignition switch to the "ON" position (models without "keyless access with push-button start system").
- Turn the push-button ignition to the "ACC" position (models with "keyless access with push-button start system").
NOTE
Only registered keys will stop the alarm. If the immobilizer transponder is not registered, the alarm will not stop.
Activating and deactivating the alarm system
To change the setting of your vehicle's
alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to
"Disarming the system" 2-30.
2. Sit in the driver's ...
Other materials:
Dtc p0801 reverse inhibit control circuit/open
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0801 REVERSE INHIBIT CONTROL CIRCUIT/OPENDTC DETECTING CONDITION:Immediately at fault recognitionNOTE:For diagnostic procedures, refer to “BODY CONTROL SYSTEM (DIAGNOSTICS)”. ...
Preparation for screen settings
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the
button to show
the selection screen.
3. After the selection screen is displayed,
operate the "
" or "
" switch to show the
"Screen Setting" item. Then, push the
button. ...
Installation
EXHAUST(H4DO) > MufflerINSTALLATIONInstall in the reverse order of removal.NOTE:• Use a new gasket and self-locking nut.• After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.Tightening torque:10 N·m (1.0 kgf-m, 7.4 ft-lb)Ti ...
