Subaru Crosstrek Service Manual: Specification
DRIVE SHAFT SYSTEM > General Description
SPECIFICATION
1. PROPELLER SHAFT
Propeller shaft type | EDJ | |
Front propeller shaft joint-to-joint length: L1 | CVT | 675.5 mm (26.59 in) |
MT | 735.5 mm (28.96 in) | |
Rear propeller shaft joint-to-joint length: L2 | 723 mm (28.46 in) | |
Outer diameter of tube: | D1 | 63.5 mm (2.50 in) |
D2 | 57.5 mm (2.26 in) | |
2. FRONT DRIVE SHAFT ASSEMBLY
Type of drive shaft | Axle diameter φ mm (in) | Axle length mm (in) |
EBJ + PTJ | 22 (0.87) | 356.4 (14.03) |
(A) | Axle diameter | (B) | Axle length |
3. REAR DRIVE SHAFT ASSEMBLY
Model | Type of drive shaft | Axle diameter φ mm (in) | Axle length mm (in) |
CVT model | BJ + DOJ | 22 (0.87) | 394.2 (15.52) |
MT model | EBJ + DOJ | 22 (0.87) | 388.5 (15.30) |
(A) | Axle diameter | (B) | Axle length |
Caution
DRIVE SHAFT SYSTEM > General DescriptionCAUTION• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if ...
Component
DRIVE SHAFT SYSTEM > General DescriptionCOMPONENT1. PROPELLER SHAFT(1)Propeller shaft(3)Rear differential (T-type)Tightening torque: N·m (kgf-m, ft-lb)(2)Rear differential (VA1-type) T1:31 ...
Other materials:
Inspection
MECHANICAL(H4DO) > Cylinder BlockINSPECTION1. CYLINDER BLOCK & PISTON1. Visually inspect to make sure that there are no cracks, scratches or other damage.2. Use liquid penetrant tester on the important sections to check for fissures.3. Check that there are no traces of gas leaking or water le ...
Dtc p060a internal control module monitoring processor performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P060A INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCENOTE:For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCE ...
Charge warning light
If
this light illuminates when the engine is
running, it may indicate that the charging
system is not working properly.
If the light illuminates while driving or does
not turn off after the engine starts, stop the
engine at the first safe opportunity and
check the alternator belt. If the ...
